EXPERIENCE THE NATURAL WAY OF WATERCARE

SpaBalancer water care instructions

SpaBalancer water care can vary between different types of whirlpools. There are several factors that determine this:

  • water volume
  • temperature
  • filtration

We distinguish between hard shell spas, inflatable spas / softubs and SwimSpas. Please refer to the dosage quantities according to your spa type.

General Information

Disinfection, lime, pH-value and filter cleaning

DISINFECTION

SpaBalancer Basic encapsulates bacteria and dirt. The filters help you to remove the encapsulations from the pool. UltraShock is especially effective against biofilms and kills bacteria, viruses and fungi.


IMPORTANT:

During the first 2 weeks there should always be at least 0.3 mg/l UltraShock in the water. Measure the day after the addition. If your water becomes cloudy, the UltraShock dosage must be increased again so that 0.3 mg/l UltraShock is present in the water. Repeat this process until the water remains crystal clear and odourless during the regular weekly addition of UltraShock.

LIMESTONE

The harder the water, the more lime it contains. If lime precipitates, it will settle on the shell and in the pipes. Then it is a basis for biofilms and makes water purification more difficult. Limestone precipitation is related to the pH of the water. This is why the pH value should always be between 6.5 and 7.8. With pH values above 8.0, lime precipitation can occur. Check the pH value 1-2 times a day for a new filling and once a week for regular use.

HOW DO I REGULATE THE PH VALUE?

First measure the pH value. Then add about one tablespoon of pH-Minus to the water. Let the pumps run for about 5 minutes. Measure the pH value again 2 hours later. From the difference to the first measurement you can estimate how much pH reducer you still have to add to the water.


PLEASE NOTE: In the first few days, the pH value can quickly rise very high. In this case it may be necessary to adjust the pH value twice a day.

FILTER CLEANING

The filters collect suspended particles and the gel that SpaBalancer Basic forms by encapsulation. Without cleaning, the filters will clog and make water cleaning more difficult. The filters should be cleaned with a filter spray and filter cleaner, e.g. FilterClean Natural. When refilling, the filters should be cleaned 1-2 times a week. In regular operation one cleaning every 1-2 weeks is sufficient.